How thorough is your knowledge of plumbing? If so, do you want to make it better? Just what are your plumbing skills? If you need to learn more about plumbing, check out the tips in the article below.

You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.

Do not use the liquid cleaning supplies that are designed to clear clogs. These cleaners are harmful and can damage your pipes as they clear the clog. Instead of using damaging liquids, use a plunger or a plumbing snake. These are much more effective and will not harm pipes.

Ensure that everyone in your household knows how to turn off the main water supply, or knows how to contact someone who can. In the event of a burst pipe or other water-related emergency, you should immediately turn off the water to prevent flooding, structural damage, and a sky-high water bill.

Frozen and bursting pipes from harsh winter weather is a problem that no-one wants, so plan now to winterize your exterior faucets and pipes against freezing conditions. A simple way to accomplish this is to find the exterior water shut-off valve located inside your home (often located in the basement). Turn off the water valve to stop water flow, and then open up the outside faucets to drain out any water that has collected. Be sure to turn off the outside water faucets tightly after the water has drained out. Take in any hoses you may have outside so they don’t crack from the cold weather.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Are you more informed when it comes to plumbing? Find out more about the specific system you have. Do you feel your skills have improved? Have you figured out how to use the things that work will work with the system that you have? Are you aware of exactly how to correctly operate the equipment? Hopefully, you are able to answer all of these questions positively and have furthered your plumbing knowledge.